Connecting Multiple Uf-20R / 5; Switching On/Off - Monacor International JTS UF-20S/5 Mode D'emploi

3) For power supply:
UF-20R / 5: Connect the mains jack (11) to
a mains socket (230 V/ 50 Hz) via the mains
cable provided
UF-20S / 5: Connect the power supply unit
provided to the power supply jack (11) and
to a mains socket (230 V/ 50 Hz) The receiver
is provided with a hook for strain relief (12):
Lead the cable around the hook to prevent
accidental disconnection of the power supply
unit from the receiver
Note: The receiver or the power supply unit will
still consume power when the receiver has been
switched off Therefore, always disconnect the mains
plug or the power supply unit if the transmission
system is not operated for a longer period of time

3.1.1 Connecting multiple UF-20R / 5

Figure 4 shows interconnection of multiple re-
ceivers UF-20R / 5 For interconnection, only two
antennas and a mains cable are required The
other short connection cables are also supplied
with the receivers This is a convenient way of
interconnecting up to ten UF-20R / 5
~ 230 V
1. UF-20R/5
2. UF-20R/5
3.
...
10. UF-20R/5
Fig. 4 Connecting up to ten UF-20R / 5
Audio channel 1
Freq. Range: AF OUTPUT
BALANCED
530-605MHz
Serial No.:
AF OUTPUT
BALANCED
Audio channel 3
AF OUTPUT
Freq. Range:
BALANCED
530-605MHz
Serial No.:
AF OUTPUT
BALANCED
Audio channel 19
Freq. Range: AF OUTPUT
530-605MHz BALANCED
Serial No.:
AF OUTPUT
BALANCED

3.2 Switching on/off

1) Press the button
ceiver In normal mode, the display (6) lights
up in orange If it lights up in red and an
error message appears periodically, the reason
may be:
No Signal
transmitter has been switched off or uses a
different transmission frequency than the re-
ceiver ( ☞ chapter 3 5)
Mic. Mute
transmitter is muted (refer to the correspond-
ing manual)
= The batteries of the wireless micro-
phone / transmitter are almost discharged
Antenna B In
RF B Out 12V out
AF OUTPUT
BALANCED
Antenna B In
RF B Out 12V out
AF OUTPUT
BALANCED
Antenna B In
RF B Out 12V out
AF OUTPUT
BALANCED
(10) to switch on the re-
= The wireless microphone /
= The wireless microphone /
Audio channel 2
AF OUTPUT
BALANCED
Antenna A
RF A Out In
12V out
Audio channel 4
AF OUTPUT
BALANCED
Antenna A
RF A Out In
12V out
Audio channel 20
AF OUTPUT
BALANCED
Antenna A
RF A Out In
12V out
17