Aqua Medic aquasunlight NG + Timer Mode D'emploi page 12

Activation: Press „ENTER" and „II / DEL" together for 3 seconds. „CP" appears shortly.
Deactivation: Press „ENTER" again and „II / DEL" buttons together for 3 seconds.
Notes for operation:
Indication appears only in case of low voltage of the 3 V battery CR 2032.
In case of decreasing range: Check the 12 V battery A23 and replace, if necessary.
Do not expose the device to excessive heat, direct sunlight or moisture.
F = 433.92 MHz
1. ON/OFF Transmission signal display
2. UNIT code display
3. Battery state
4. Memory sets (max. 12)
5. Timer display
6. On-Time
7. Off-Time
8. Daily cycle
9. Single connection
10. Safety mode
11. House code
12. Battery 3 V CR2032
13. Battery 12 V A23 (replace in case of decreasing range)
2. Receiver
The receiver is programmed by the factory. The following procedure is only necessary for
changes.
1.) Press adjustment button (I, II or III) of the selected channel (exit) briefly at the receiver (1 sec.). LED
is flashing.
2.) Press button „ON" at the transmitter immediately. Now, the receiver switches twice as a sign that the
code was accepted.
This procedure is repeated for further connections.
12