Publicité
Les langues disponibles
Les langues disponibles
Timer sunlight NG
Operation manual ENG
1. Transmitter:
Preparation:
Setting time ▲▼:
Press the „CLOCK" button for approx. 3 seconds until LCD display is flashing.
Set the hour with „▲▼" buttons. Press ENTER to save.
Set the minutes with „▲▼" buttons. Press ENTER to save.
Now, the timer is ready for operation.
Next step:
The house code (A – P) has to be the same both on all receivers and on the TIMER (preselection: A)!!
Use as hand-held transmitter for all sunlight 433.92 MHz receivers:
Select the code (1 – 16) by pressing the „UNIT" button. Now, the selected receiver can be directly
connected by pressing the „ON" or „OFF" button, even during the setting as active timer.
You can choose between 3 different timer modes:
A) Daily cycle
: (
) Activates the set switching times daily.
B) Single connection: (
) Activates the set switching times only once.
C) Safety mode: (
) The timer connects randomly within the set switching times. Simulates presence
(protection against burglary and theft).
Timer settings:
1.) Press „TIMER" button for approx. 3 seconds.
2.) Enter the memory location (1 to 12) using „▲▼" buttons. Confirm with „ENTER".
3.) Enter the number of the device (1 to 16) using the „UNIT" button. Confirm with „ENTER".
4.) Enter the turn-on/turn-off times using „▲▼" buttons. Confirm with „ENTER".
5.) Select the TIMER MODES using „▲▼" buttons
(
,
oder
).
Confirm with „ENTER".
6.) To exit, press „TIMER" button briefly.
Check of timer settings:
Press „TIMER" button for 3 seconds and select memory location using „▲▼" buttons. To exit, press
„TIMER" button briefly.
Deactivation of single timer settings (pause function e. g. for the weekend):
Press „TIMER" button for 3 seconds. Select the memory location you want using „▲▼" buttons. Press
„II/DEL" button briefly and confirm with the „ENTER"button. Thus, the selected timer memory will be
deactivated. A border enclosing the number of the memory location appears in the display. To exit, press
„TIMER" button briefly.
Activation of the memory location:
Same procedure as with deactivation. The border of the memory location number disappears.
Reset of timer settings:
Press „TIMER" button for 3 seconds. Select the memory location you want using „▲▼" buttons. Press
„II/DEL" button for 3 seconds to reset the selected memory location. By pressing „ENTER", the memory
location reset will be confirmed and the location will be free.
Press the „TIMER" button briefly for switching to the standby mode.
Child lock (prevents unintentional setting of the timer settings):
11
Publicité
