Set Point Setting; Code Description - Ferroli AQUA1 PLUS Manuel D'utilisation

Manuale utente
3.1.3.4

Set point setting

By specific procedures described below the
set points SP1, SP2 and SP3 can be changed.

Code Description

Requested
SP1 temperature inside the
tank in ECO mode
Requested
SP2 temperature inside the
tank in AUTO mode
Lower value of water
temperature to swith on
SP3
the electrical booster in
Auto Mode
The default values can be changed within
the range of defined by parameters r1, r2, r3
and r4. This parameter can be modified by
the installer\ service procedure.
3.1.3.5 Temperature setting in the ECO
operating mode (SP1)
Make sure that the keyboard is not locked and
that no other advanced procedure is in
progress
;
Press and release the
shown on the display;
Press and release the
LED will flash;
Press either the
seconds;
Press and release the
out any other operations for 15 seconds: the
compressor LED will switch off;
Press and release the
To exit the procedure before its completion:
Do not carry out any operations for 15 seconds
(any changes will be saved).
3.1.3.6 Temperature setting in the Automatic
mode (SP2)
Default
value
water
55.0
water
55.0
45.0
key: "SP1" will be
key: the compressor
or the key within 15
key or do not carry
key.
Make sure that the keyboard is not locked
and that no other advanced procedure is
in progress;
Press and release the
be shown on the display;
Press either the
"SP2" is shown on the display;
Press and release the
compressor LED will flash;
Press either the
15 seconds;
Press and release the
carry out any other operations for 15
seconds: the compressor LED (
switch off;
Press and release the
To exit the
completion:
Do not carry out any operations for 15
seconds (any changes will be saved).
3.1.3.7 Lower value of water temperature
setting in the automatic mode (SP3)
Make sure that the keyboard is not locked
(paragraph 3.1.3.3) and that no other
advanced procedure is in progress;
Press and release the
be shown on the display;
Press either the
"SP3" is shown on the display;
Press and release the
compressor LED will flash;
Press either the
15 seconds to set value.
Press and release the
carry out any other operations for 15
seconds: the compressor LED (
switch off;
Press and release the
To exit the procedure before its completion:
Do not carry out any operations for 15
seconds (any changes will be saved).
3.1.3.8 Day and real time settings
key: "SP1" will
or the key until
key: the
or the key within
key or do not
) will
key.
procedure before its
key: "SP1" will
or the key until
key: the
or the key within
key or do not
) will
key.
pag. 7 / 14