Basic Management - Ferroli AQUA1 PLUS Manuel D'utilisation

Manuale utente
in the event that a temperature exceeding
56°C is required;
ECONOMY operating mode
This mode uses only the renewable energy of
the heat pump without ever enabling the
electric heating elements. It takes longer to
enable but it has considerable energy saving
characteristics;
OVERBOOST operating mode
This mode makes it possible to heat water
rapidly by using both the heat pump and the
electric heating elements. This function can be
manually enabled when the temperature of
the water inside the storage tank is below
40°C. At the end of the heating process, the
function is automatically disabled and the
equipment is automatically restored to the
Automatic or Economy mode depending on
which of these functions was previously set by
the user;
ANTI-LEGIONELLA
This function is used as an anti-bacterial
treatment by increasing the temperature of
the water to 70°C. This function is periodically
and, in any case, automatically enabled every
30days, regardless of the operating mode
enabled;
DEFROSTING mode
This function is necessary in order to eliminate
the frost deposits that form and which prevent
heat transmission. This function is automatically
enabled when the equipment is operated at
low environmental temperatures.
When the equipment is switched on for the
first time, it is pre-set by the manufacturer in
the ECO (Economy) mode with a water set
point of 55°C with the aim of guaranteeing
the best possible energy saving function
with the support of only renewable energy
sources. Please note that the use of such
function guarantees the user an average
energy saving of approx. 70% when
compared to a normal electric boiler.
3.1.3

Basic management

3.1.3.1 Manual switching on /off of the
equipment
Keep the key pressed for 1 second: the
on/stand-by LED will switch off/on.
The equipment can be switched on/off also
in certain timeslots; the parameters HOn and
HOF if the temperature required is not more
than 56 °C (SP5 parameter).
Manual switching on/off always has the
priority over the timeslot operating mode.
operating mode
If the keyboard has been locked or an
advanced procedure is in progress, it will
not be possible to carry out the normal
switching on/off of the equipment.
Every time the equipment is switched on,
a series of internal inspections are carried
out before the heat pump is enabled. Such
condition is reported by means of the
flashing of the compressor indicator light
. Once the verification period has
passed (approx. 5 minutes) the indicator
light remains lit and this indicates that the
unit is switched on.
3.1.3.2 Change of operating mode
(AUTOMATIC, ECONOMY and
OVERBOOST)
If you want to change the operating mode,
than the one set press
The display will show the other available
modes.
Using the key or the key
desired one.
Press and release the button
your choice.
To exit the procedure:
Press the key to exit this procedure without
changing the mode.
3.1.3.3 Keyboard locking/unlocking
To lock the keyboard, carry out the following
procedure:
Make sure that no other advanced procedure
is in progress;
Keep the and the
second: "Loc" will be shown on the display for
1 second.
If the keyboard is locked, it will not be possible to
carry out any kind of operation on the display
interface.
By pressing any key, "Loc" will be shown for
1 second on the display.
To unlock the keyboard:
Keep the and the
second: "UnL" will be shown for 1 second on
the display.
for one second
to select the
to confirm
keys pressed for 1
keys pressed for 1
pag. 6 / 14