Westfalia 344 250 391 101 Instructions De Montage page 14

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
Installing the electrical kit
1. Disconnect the negative battery terminal.
2. If necessary, remove the following coverings and panels:
In the luggage trunk
Covering of luggage trunk bottom
-
Loading edge covering
-
Covering of the left side of the luggage trunk
-
On the left-hand side of the vehicle
Access strips
-
Cover of the fuse carrier
-
Fuse carrier
-
3. Fasten the trailer control module to the left-hand side of the luggage trunk (Fig. 1/3) using
velcro tape provided. Make sure it is securely fastened!
4. Remove the vehicle's 40 mm hole cover (Fig. 1/2) in the rear end plate.
5. Starting in the luggage trunk, lead the cable end through the cable leadthrough (Fig. 1/2) to
the outside to the socket holder plate (Fig. 1/1).
Installing the socket
Only for 13-pin trailer socket:
6. Insert the rubber grommet into the cable leadthrough (Fig. 1/6).
7. If there is already a rubber grommet, take it away and put this wires through the small whole
of the rubber grommet at the cable harness. Pay attention to tightness!
8. Press the contact insert into the socket housing and push the rubber grommet towards the
socket.
9. Screw the socket onto the holding plate (Fig. 1/1) using the supplied screws.
10. Secure the cable harness using cable ties.
Only for 7-pin trailer socket:
11. Slip the rubber grommet on the cable harness and adapt its length to the cable.
12. If there is already a rubber grommet, take it away and put this wires through the small whole
of the rubber grommet at the cable harness. Pay attention to tightness!
13. The lateral cable outlet at the plug socket housing carefully break off.
14. Fit the socket gasket and connect the cable harness to the socket housing in accordance with
the pin assignment plan (Fig. 1/1) and push the rubber grommet against the socket.
15. Screw the socket onto the holding plate (Fig. 1/1) using the supplied screws and nuts.
16. Secure the cable harness using cable ties.
14
344 250 391 101 - 003 - 24/10
Installation Instructions:
Electrical System for Towing Hitch
Skoda Fabia II FL, Skoda
Roomster FL, Seat Ibiza V

Publicité

Table des Matières
loading

Table des Matières