Working Advice - Bosch GML 20 Professional Notice Originale

OBJ_BUCH-1181-001.book Page 26 Monday, March 1, 2010 12:07 PM
26 | English

Working Advice

Recommendations for Optimal Handling of the
Battery
Protect the battery against moisture and water.
Store the battery only within a temperature
range between 0 °C and 45 °C. As an example,
do not leave the battery in the car in summer.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
Troubleshooting Causes and
–
Corrective Measures
Cause Corrective Measure
Construction site radio inoperative
No power supply Properly insert mains
plug or battery (com-
pletely)
Construction site ra- Wait until the con-
dio too warm or too struction site radio
cold has reached operating
temperature
Construction site radio inoperative on A/C
power supply
Mains socket faulty Use another socket
Mains plug or cord de- Check mains plug and
fective cable and have re-
paired as required
Construction site radio inoperative on DC
power supply
Battery contacts con- Clean the battery con-
taminated tacts (e.g. by inserting
and removing the bat-
tery several times) or
replace the battery
Battery defective Replace the battery
Battery too warm or Wait until of the bat-
too cold (temperature tery has reached oper-
warning indicator k lit) ating temperature
1 609 929 W27 | (1.3.10)
Cause Corrective Measure
Power supply to external devices inoperative
Mains plug not Plug mains plug in
plugged-in (completely)
12 V power supply inoperative
No fuse 32 inserted Insert fuse 32
Fuse 32 blown Replace fuse 32
Internal thermal fuse Remove external de-
blown/actuated vice and allow con-
struction site radio to
cool down
Construction site radio suddenly inoperative
Mains plug or battery Plug in mains plug or
not properly or com- battery properly or
pletely plugged in completely
Software error To reset the software,
pull the mains plug
and remove the bat-
tery; wait 30 seconds,
then insert mains plug
and battery again
Bad radio reception
Interference from oth- Position construction
er devices or insuffi- site radio at other lo-
cient set-up location cation with better re-
ception
Rod antenna not opti- Turn/change position
mally directed of rod antenna
Time indication faulty
Back-up batteries of Replace back-up bat-
clock empty teries
Back-up batteries in- Insert back-up batter-
correctly inserted ies correctly
(wrong polarity)
When the corrective measures do not eliminate
an error, please contact an authorised service
agent for Bosch power tools.
Bosch Power Tools