Tools You Will Need (Not Provided); Cabinet Constructing Instructions; Cabinet Installation - Furrion FT24N62R-SS Manuel D'utilisation

Tools You Will Need (Not Provided)

Part
Electric Drill
(Drill bit diameter for the anchor is 5/16" 8mm).
Safety Goggles
Gloves
Adjustable Wrench
Tape Measure
Pencil
Phillips Screwdriver (M4, +Type Head)
Flat Blade Screwdriver
Cutting Knife
Level
(UL Listed 50 AMP)
4-Wire Cord 6' long OR
3-Wire Cord 6' long
Mounting Anchors for masonry/cement
floors.

Cabinet Constructing Instructions

● For proper operation of your range, the cabinets must be
properly constructed and squared with respect to the
counter top and the cabinet face.
● For proper operation of these units, the cabinet must be
level and the bottom of the range must be supported. Use
an insulated pad or ¼" (64mm) plywood under the range if
installing the range over carpeting.
NOTE: When planning the location, consider curtains
or other combustible materials installed around the
appliance so as not to create a fire hazard.
● All openings in the counter or floor where the range is to be
installed must be sealed.
● The floor anti-tip bracket must be installed properly. To install
the anti-tip bracket shipped with the range, refer to "Anti-
Tip Bracket Installation" section for the detail installation
instructions of the anti-tip bracket shipped with the range.
● Grounded electrical supply is required. Refer to "Electric
Connection" section.
● Maximum allowable wood cabinet temperatures of 194°F
(90°C).
Description

Cabinet Installation

● The minimum horizontal distance(s) from sides and
top of appliance to adjacent vertical combustible walls
extending above the top panel. (Fig. 1)
Fig. 1
Item
The minimum vertical distance to combustible
A
material to the side the range cooking surface.
The minimum vertical distance to the
combustible distance over the range.
NOTE: 24" (610 mm) minimum when bottom
of wood or metal cabinet is covered by
B not less than ¹/₄" (64mm) flame retardant
millboard covered with not less than No. 28
MSG sheet steel, 0.015" (0.4mm) stainless
steel, 0.024" (0.6mm) aluminum or 0.020"
(0.5mm) copper.
C Maximum upper cabinet depth.
NOTE: If installing a range hood or microwave hood
combination above the cooking surface, follow the
range hood or microwave hood combination installation
instructions for dimensional clearances above the cooking
surface.
Counter Cutout Dimensions (Fig. 2)
C
A
Fig. 2
A
36" Recommended
Min. 235/8" (600mm)
914mm Recommended
Dimension
18"
457mm
30"
762mm
15"
381mm
B
M in . 2
½ "
( 6 4 m
m )
M in . 2
½ "
( 6 4 m
m )
B C
Min. 24" (610mm)
8