Wall Bracket - SAD Diamond Manuel D'utilisation

OPTIONAL EXTRAS FOR DIAMOND RANGE
FLOOR STAND
Parts Included:
Bracket x 1
Floor stand x 1
Thumb screws x 2
Thumb nut x 1
Thumb screw retainers x 2
(these are white, and only secure
the parts together for transit)
Tools required: A flat blade screwdriver
1 Remove handle and base from lightbox if already fitted.
2 Then remove the small white retainers from the bracket.
3 Place lightbox face down on a table or firm surface.
4 Offer the bracket up to the two central mounting points as
shown in Diagram 2, and tighten thumb screws.
of the holes in the bracket goes towards the base of the lightbox.
5 Set up the stand by extending the central pole to
the maximum length and lock the bottom knob
to hold secure. (The pole is telescopic. To release
piece inside you need to undo the long 'collar' and
extend the rest of the pole. Tighten the collar again.)
6 Remove the thumb nut.
7 Lift lightbox up and slot holes over the pole of
the floor stand and push down until you are able
to replace thumb nut, and tighten.

WALL BRACKET

Parts Included:
MOUNTING
POINTS
70 70
FOR
BRACKET
Items required: A screwdriver
320
Diagram 2
1 Remove handle and base from lightbox if already fitted.
2 Remove the small white thumb screw retainers from bracket.
3 Place lightbox face down on a table or firm surface.
4 Offer the bracket up to the two central mounting points as
N.B. The larger
5 The wall bracket then needs to be attached to the wall.
6 Remove the two centre thumb nuts and lift the lightbox up
2 Extend
Telescopic
pole
7 Tighten the thumb nuts, adjust position of lightbox and then
1 Unscrew
Collar
Bracket x 1
Thumb screws x 2
Thumb nut x 2
Thumb screw retainers x 2 (these are white and only secure
the parts together for transit)
4 Screws (we recommend size 8 x 1
minimum)
4 Rawl plugs for the type of wall in your home
shown in Diagram 2, with the rubber grommet at the bottom
of the lightbox, and tighten thumb screws.
and offer it up to the wall bracket. The wall bracket can be
attached to the lightbox bracket at either the top, middle or
bottom fixing points as required.
tighten the T bar to lock the universal ball joint.
1 / " (38mm)
2