Bresser 9119501 Mode D'emploi page 14

Masquer les pouces Voir aussi pour 9119501:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DANGER!
Be extremely careful when using the MicroCut, knife or scalpel. These instruments are very
sharp and pose a risk of injury.
Place the slices on a glass slide and cover them with another slide before attempting to view them with
the microscope.
6.3. Creation of your own preparation
Put the object to be observed on a glass slide and cover the object with a drop of distilled water using the
pipette (14).
Set a cover glass (available at a well-stocked hobby shop) perpendicular to the edge of the water drop, so
that the water runs along the edge of the cover glass. Now lower now the cover glass slowly over the water
drop.
7. Experiments
Now that you're familiar with your microscope's functions and how to prepare slides, you can complete the
following experiments and observe the results under your microscope.
7.1. How do You Raise Brine Shrimp?
Accessories (from your microscope set):
1. Shrimp eggs
2. Sea salt,
3. Hatchery,
4. Yeast.
The Life Cycle of Brine Shrimp
Brine shrimp, or "Artemia salina, " as they are called by scientists, have an unusual and interesting life cycle. The
eggs produced by the female are hatched without ever being fertilized by a male shrimp. The shrimp that hatch
from these eggs are all females. In unusual circumstances, e.g. when the marsh dries up, the male shrimp can
hatch. These males fertilize the eggs of the females and from this mating, special eggs come about. These
eggs, so-called "winter eggs, " have a thick shell, which protects them. The winter eggs are very resistant and
capable of survival if the marsh or lake dries out, killing off the entire shrimp population. They can persist for
5-10 years in a "sleep" status. The eggs hatch when the proper environmental conditions are reproduced. These
are the type of eggs you have in your microscope set.
The Incubation of the Brine Shrimp
In order to incubate the shrimp, you first need to create a salt solution that corresponds to the living conditions
of the shrimp. For this, put a half liter of rain or tap water in a container. Let the water sit for approx. 30 hours.
Since the water evaporates over time, it is advisable to fill a second container with water and let it sit for 36
hours. After the water has sat stagnant for this period of time, add half of the included sea salt to the container
and stir it until all of the salt is dissolved. Now, put a few eggs in the container and cover it with a dish. Place the
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

National geographic microscope 40x - 640x

Table des Matières