Hendi 208502 Mode D'emploi page 11

Preparing the appliance for use
1. Place the coffee machine on a stable flat surface.
2. Put the filter in the holder.
3. Fill the coffee pot with cold water and pour it in the water reservoir. Wait 1 minute for the water to
force the air out of the appliance.
4. Place the empty coffee pot in the correct position under the filter pan.
5. Turn the power switch ON.
6. HOT WATER will soon start dripping into the pot.
7. The in-use indicator lamp will turn off in 4 or 5 minutes .
8. Repeat steps 3 to 7 a few times to clean the appliance thoroughly before making coffee for the
first time.
9. It is normal for steam to escape during this process and for the dripping water to make gurgling
sounds.
► Never pour hot water in the water reservoir.
► Check to make sure that the filter is positioned correctly:
•
Place the spring and spring holder at the bottom of the filter pan.
•
Place the paper filter on the spring in the filter pan.
Making coffee
To make coffee follow these steps:
1. Prepare the filter pan as described above. Add the desired amount of ground coffee, depending
on your taste. The recommended amount is 75-90 gm per pot of water (1.6-1.8 litre).
2. Place the filter pan in the holder.
3. Fill the coffee pot (glass decanter, vacuum pot or thermos depending on model type) with the
desired amount of water and pour it in the water reservoir.
4. Place the empty pot directly under the filter pan.
5. Turn the power switch ON. The in-use indicator lamp will light up to indicate that the machine
has started to operate.
6. After some time coffee will start to drip into the coffee pot.
7. When all of the water has passed through the machine, the in-use indicator lamp will switch off.
8. Turn off the power switch and close the thermos (if applicable) by twisting the lid on. The coffee is
ready to be served.
9. The appliance has an overflow tube to allow extra water in the reservoir to escape, but since the
coffee pot can hold only 1.8 litres of water we recommend that you never fill the reservoir with
more than 1.8 litres of water.
10. Some water will always be left in the machine and in the tubes. If you do not use or move the
appliance for a long time, it is best to empty the appliance and clean it before storing it.
11. If you have emptied the appliance (as recommended in no. 10 above), before using it again you
should repeat steps 1-7 of Preparing the appliance for use.
12. If you haven't used the appliance for a short time, rinse it out with clean water before use.
►Do not forget to turn the appliance off after use.