Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4 The pod could remain stuck in the upper part of the machine after making the coffee and when
removing filter holder. To remove it, tilt the filter holder (Fig. 18) so the pod can fall onto it.
To always have a good coffee, you must purchase pods that show the E.S.E. compatibility mark.
If the pod is not inserted well, or if the filter holder is not tightened firmly, a few drops of
water could leak from the filter holder.
Auto-off function
If the machine is turned on but not in use, the auto-off function operates after about 30 minutes.
This function puts the machine in standby. The ON indicator light (R) is off. To restart the machine
press again the power button (J).
Filling the water tank during use
No special operation is necessary when the water in the tank runs out as the machine is equipped
with a special self-priming device. Just unplug the machine, pull out the tank and fill it with fresh
cool water again.
HOW TO MAKE CAPPUCCINO
To prepare cappuccino, hot chocolate, or heat any other beverage, turn the switch (O) to the steam
position ( ) and wait that the indicator light (N) turns on to indicate that the boiler has reached the
right temperature to dispense steam (about 150 °C / 300 °F).
When warming up, your appliance may release small puffs of steam from the filter holder;
this is perfectly normal.
Place a glass under the Maxi Cappuccino device (H). Turn the steam knob (M): at first a little water
will come out, immediately followed by a strong jet of steam.
Close the dispensing knob (M) to stop the jet of steam and put the pot of milk to be whipped under
the Maxi Cappuccino device (Fig. 12). Plunge the wand all the way into the pot of milk and again
open the steam dispensing knob (M) until you get the result you want. During these operations, you
will see that the indicator light (N) turns on and off periodically, indicating the action of the thermo-
stat which maintains the proper temperature of the boiler for steam dispensing.
It is opportune you start dispensing the steam only when the lamp is on. After each use,
dispense the steam for a few seconds to clear the outlet from any milk residue.
Close the steam knob (M). After preparing the cappuccino return the switch (O) in the upper posi-
tion to exclude the steam function.
MAKING FURTHER CUPS OF COFFEE
To prepare a cup of coffee right after making cappuccino, it is necessary to bring the boiler back
to the coffee preparation temperature by performing these operations: return the switch (O) in the
upper position to cool the boiler and wait that the light (N) goes out and comes on again. To cool
the heating unit more quickly, proceed as follows: place a glass under the Maxi Cappuccino device
(H). Turn the switch (Q) to position (
); turn the steam knob (M): this will cause water to flow out,
until the warning light (N) turns back off. Now close the steam dispensing knob (M) and return the
switch (Q) in the upper position. Wait for the light (N) to turn on. The coffee maker is now ready to
brew coffee again.
19
Publicité
Table des Matières
