Troubleshooting Guide - Metabo HPT VB 3616DA Mode D'emploi

● To avoid injury from an accidental start, turn the switch OFF and remove the plug from the power source
or remove the battery from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualifi ed service technicians. Contact the
metabo HPT Authorized Service Center.
1. Power tool
Problem
Does not move
Suddenly stopped
Switch cannot be pulled
Hear a "beep" when pulling
on the switch
Cannot cut satisfactorily
Have trouble holding rebar
when cutting
Cannot bend properly
Cannot install battery

TROUBLESHOOTING GUIDE

WARNING
Possible Cause
No battery remaining.
Battery is not properly installed.
The tool remains in reverse-rotation mode Press the Manual Mode switch to cancel
Overload protection circuit activated.
Heat protection circuit activated due to
overheating of the battery or the tool itself.
Insuffi cient pressure on the switch lock.
Switch is pulled in a small amount.
Cutter is worn/degraded/damaged
Working tool outside of its normal
capacity (material, material diameter,
processing quantity).
Grip rubber is worn.
Working tool outside of its normal
capacity (material, material diameter,
processing quantity).
Attempting to install battery other than
type specifi ed.
Possible Solution
Charge the battery.
Push battery in until a click is heard.
reverse-rotation.
Remove cause of overload.
Allow battery and tool to fully cool down.
Press switch lock in until it comes to the
end.
Not a problem.
Pull harder on the switch and the sound
will stop.
Replace with a new cutter.
Review "Specifi cations" to cut properly.
Replace with new grip rubber.
Contact the metabo HPT Authorized
Service Center.
Review "Specifi cations" to bend properly.
Use Multi Volt type battery.
English
29