Prior To Operation - Metabo HPT VB 3616DA Mode D'emploi

(1) Select a charging method
Depending on the charge method selected, either the
battery is inserted into the charger or the power cord
is plugged into an outlet.
○ Charging a USB device by battery (Fig. 11-a)
○ Charging a USB device from a electrical outlet
(Fig. 11-b)
○ Charging a USB device and battery from a
electrical outlet (Fig. 11-c)
a
(2) Turn the USB power switch ON (Fig. 12)
When you turn the USB power switch ON, the USB
power indicator lamp will light up.
Rubber cover
USB port
USB cable
(3) Connect the USB cable. (Fig. 12)
Pull back the rubber cover and fi rmly plug in a
commercially available USB cable (appropriate to the
device being charged) into the USB port.
○ When the power cord is not plugged into an outlet
and the battery runs out of power, power output will
stop and the USB power indicator lamp will shut off .
○ When the USB power indicator lamp goes out,
change the battery or plug the power cord into an
electrical outlet.
(4) When charging is completed
○ The USB power indicator lamp will not go out when a
USB device has been completely charged.
To verify charge status, check the USB device.
○ Turn the USB power switch OFF and unplug the
power cord from the electrical outlet. (Fig. 12)
○ Remove the battery from the charger and place the
rubber cover over the USB port.
b
Fig. 11
USB power
switch
USB power
indicator lamp
Fig. 12

PRIOR TO OPERATION

CAUTION
To avoid serious accident, ensure the switch is
in the OFF position, and pull out the battery.
1. Check the work area environment
Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
2. For safety sake, use the provided hexagonal bar
wrench to make absolutely sure that the hexagon
socket bolt is securely clamped. Use of the unit with
the bolt in a loosely clamped condition can result in
damage to the unit and cutter as well as accidents.
3. Confi rm that the cutter is in sharp condition.
Make certain that the cutter is in a sharp condition.
c
Continued use of a worn out and deformed cutter with
dull edges results in damage to the unit and cutter as
well as accidents.
4. Check battery insertion
WARNING
If the battery is inserted while the power switch
is in the ON position, the power tool will start
operating immediately, inviting serious accident.
CAUTION
Until the battery locks in place with a little click,
if not, it may accidentally fall out of the tool
causing injury to you or someone around you.
English
15