Metabo HPT VB 3616DA Mode D'emploi page 22

English
(1) Position the setting dial in the "CUT" position (Fig. 34)
Alignment position
(2) Set the rebar to be cut above the lower cutter (Fig. 35)
Make sure that there is enough length for the rebar to
fully hook reaction stopper B.
Reaction stopper B
Rebar
Bending roller
(3) Press the switch lock in either direction to release the
lock, and pull the switch to cut the rebar.
After cutting the rebar, hold down the switch until the
motor completes its reverse-rotation and the upper
cutter begins its return.
22
Setting Dial
CUT
Turn the setting
dial all the way
to the right
Fig. 34
Lower cutter
Fig. 35
3. Cutter Replacement
After following the steps for "1. Inspect the cutter
and grip rubber" (steps (1) through (5)), follow the
instructions below. Replace the upper and lower
cutters as one set.
(1) Using the included hexagonal bar wrench, remove
the hexagon socket bolt and then remove the upper
and lower cutters. (Fig. 36, 37)
Removing the upper cutter
Hexagon socket bolt
Hexagonal
bar wrench
Loosen
Pushing the cutter guard upwards makes it easier to
remove the upper cutter.
Removing the lower cutter
Hexagonal
bar wrench
Lower cutter
Hexagon
socket bolt
Loosen
Prying with a fl athead
screwdriver will make
it easier to remove the
lower cutter.
Cutter guard
Push upwards
Upper cutter
Fig. 36
Reaction stopper B
Fig. 37