Metabo HPT VB 3616DA Mode D'emploi page 17

OPERATION
WARNING
● Never touch the moving parts.
CAUTION
● To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
● Pull out the battery after completing operation.
1. Switch operation
This product is equipped with a switch lock to prevent
inadvertent switch operations.
Pressing the switch lock in one of the indicated
directions and pulling the switch will activate the
motor.
Once the switch is activated, it will remain on even
after releasing the switch lock as long as you are
pulling on the switch. (Fig. 16)
1 Lock release
Press the switch lock
in either direction
2 Pull the switch
Fig. 16
Releasing the switch within area 1 will apply a brake that
will stop operation. (Fig. 17)
Releasing the switch within area 2 will automatically
return the upper cutter and bending roller to their original
positions. (Fig. 17)
1 Turns up to
the set angle
2 Automatically
returns to
original position
Bending roller
2. Reverse-rotating the cutter and bending roller
Releasing the switch during operation could result in
the cutter and bending roller coming to a standstill to
sandwich the rebar and irremovably lock it in place.
(Fig. 18)
Irremovable
Rebar
Irremovable
Upper cutter
In this situation, the motor should be reverse-rotated
to return the cutter and bending roller back to their
original positions.
Below are the two methods for returning the cutter
and bending roller during operation. (Fig. 19, 20)
English
Set angle
Keep switch drawn
up to this point
Cutter also
simultaneously activates
and the cover closes!
Fig. 17
Rebar
Bending roller
Fig. 18
17