Metabo HPT VB 3616DA Mode D'emploi page 18

English
Set the setting dial on "RETURN"
1 Align the position of the
set dial to "RETURN"
2 Pull on the switch once
again
Reverse-rotation mode
Once the tool begins
moving back, it will return
to its original position
even if the switch is
released.
Press the Manual Mode switch to move back
1 Press the Manual Mode
switch
Manual Mode switch
Red indicator
lamp
switches on
2 Pull the switch once again
Reverse-rotation mode
The tool will move back
as long as the switch is
pulled.
The tool will stop once
it returns to its original
position.
3 When returned to the
original position, press
the Manual Mode switch
Regular rotation mode
18
Alignment position
Switch
Fig. 19
Switch
Fig. 20
NOTE
The tool will not operate if left in Reverse-rotation
mode, so press the Manual Mode switch to cancel
reverse rotation.
3. About the warning signal (Fig. 21, Table 5)
This product has a function to protect the tool as well
as its controls.
During work, from the time the switch is being pulled
and three seconds after its release, each of the
protective functions may be activated, resulting in the
Manual Mode switch's mode indicator lamp to blink in
the following manner to notify the user.
When one of the protective functions are activated,
immediately release the switch and follow the
described countermeasure instruction.
Switch panel
Manual
Mode switch
Mode indicator lamp
Fig. 21