Hitachi CJ 14DSL Mode D'emploi page 14

English
5. Switch operation
(1) Lock-off button (Fig. 9)
The jig saw is equipped with a lock-off button. To
activate the trigger lock, move the button to the
lock position. Move the button to the free position
to operate the tool.
CAUTION:
Always lock the switch when carrying or storing
the tool eliminate unintentional starting.
Lock off button
Lock
(2) Trigger switch (Fig. 10)
The number of strokes of the blade can be adjusted
to within the range of 0 to 2,400 strokes/minute
depending on the amount the switch is pulled. In
addition, releasing the switch activates a break that
stops the blade immediately.
When the switch is turned on, an LED lamp lights
to illuminate the end of the blade. This lamp goes
out when the switch is released.
CAUTION:
●
Always make sure to push in the lock off button
to the locked position when not using the saw.
●
Do not look directly into the light from the LED
lamp. Continuous and direct exposure to the light
from the LED lamp can injure your eyes.
LED light
6. Adjusting the orbital operation
(1) This Jig Saw employs orbital operation which
moves the blade back and forth, as well as up and
down. Set the change knob shown in Fig. 11 to
"0" to eliminate the orbital operation (the blade
moves only up and down). The orbital operation
can be selected in 4 steps from "0" to "III".
14
Fig. 9
Switch
Fig. 10
(2) For the hard material, such as a steel plate, etc.,
decrease the orbital operation. For the soft
material, such as lumber, plastic, etc., increase the
orbital operation to increase work efficiency. To
cut the material accurately, decrease the orbital
operation.
Free
Change knob
7. Cutting stainless steel plates
This Jig Saw can cut stainless steel plates by using
No. 97 blade. Carefully read "Concerning cutting
of stainless steel plates" for proper operation.
8. Splinter guard
Using the splinter guard when cutting wood
materials will reduce splintering of cut surfaces.
Insert the splinter guard in the space on the base,
and push it completely. (See Fig. 12)
Splinter
guard
9. Chip cover
Chip cover prevents chips from flying off and
improves the efficiency of dust collector.
Insert the chip cover between the base and lever,
and push with a slight pressure until it catches in
place. (Fig. 13)
When removing chip cover, hold both sides of knob
and slightly open until it can be removed from the
Jig Saw. (Fig. 14)
NOTE:
There is a possibility that chip cover is frosted when
cutting the metal.
Fig. 11
Base
Insert
Fig. 12