Installation With Screw Anchor - pyrexx PX-I Notice D'utilisation, D'installation Et D'entretien

tive sheet from the adhesive applied
on the magnets. Press the magnetic
to the location chosen for installation.
Afterwards, the device can be mounted
onto the magnetic holder (Fig. 1b).
Should it be necessary, the device can
then be pulled off the magnet holder
vertically.
The adhesive bond attains its final
strength after approx. 72 hours.
Installation with
screw anchor
Please leave the adhesive on the mag-
netic holder even when installing with
screw and anchor. Drill a hole at the
-
installation site and insert the screw
anchor supplied into the hole. Then
insert the supplied countersunk screw
into the bottom side of the magnetic
holder as displayed in Fig. 2, so that the
(Fig. 1b) when screwed into the anchor.
To do this, push the screw through the
perforated hole. To ensure that the
device is securely fastened, the screw
has to be completely screwed into the
recess of the magnetic holder (Fig. 1b).
Please tighten the screw securely, but
without deforming or bending the mag-
netic holder.
35
en