Installation With Adhesive - pyrexx PX-I Notice D'utilisation, D'installation Et D'entretien

34
Installation
The smoke alarm device is kept in place
by a magnetic holder (Fig. 1b). There are
two ways described below to fasten
the holder to the ceiling. Please keep in
mind that the holder is strongly mag-
netic only on one side!
en
Installation with
adhesive
Means of anchorage (magnetic holder
with self-adhesive coating on reverse
side) acc. to EN 14604: 2005/AC: 2008
Caution:
The use of this means of anchorage
establishes a very maintenance-friendly,
firm, magnetic connection between
the device and the installation surface
which makes it possible to release the
device (for example for testing / main-
tenance / cleaning) from the magnetic
holder by pulling it off vertically.
Only use the adhesive supplied with the
product when installing the device with
adhesive! The installation location must
be solid, dry and free of grease, dust and
loose paint etc.
Remove the information sticker, as
shown in Fig. 2, and then the protec-