Fitting The Grass Catcher; Connecting The Extension Cable - Medion MD 16906 Traduction De La Notice Originale

6.2. Fitting the grass catcher

 First, place the grass catcher handle on the lid of
the grass catcher into the rear recesses until it clicks
into place. Then press the other end of the grass
catcher handle into the front slots until it clicks into
place.
 Then place the lid with the rear first onto the lower
part of the grass catcher. Ensure that the 2 locking
tabs engage into the 2 locking latches. Push the
cover onto the rear lower part until it clicks audibly
into place.
 Then place the lid completely onto the lower part.
Ensure here too that the 6 locking tabs engage into the 6 locking latches. Push the
cover onto the lower part until it clicks audibly into place.
 Make sure that the lower part fits correctly into
the guides on the front of the cover.
 Now hold the grass catcher firmly by the handle;
lift the grass catcher cover (3) and insert the
catcher into the lawn mower tilted slightly
downwards. Make sure that the grass catcher sits
firmly on the retaining lugs.
 To remove the grass catcher, lift it slightly and pull
it out backwards.
6.3. Connecting the extension
cable
 Use only extension cables with a conductor cross-section of at least 1.0 mm
are approved for outdoor use.
 Plug the mains cable of the appliance into the coupling of the extension cable.
 Run the extension cable through the cable guide (9) to prevent a too high
tensile load.
86 of 98
2 that