Table des Matières
Publicité
FAMILIARISEZ-VOUS AVEC VOTRE NETTOYEUR À
VAPEUR
1.
Appareil
2.
Voyant indicateur
3.
Cordon d'alimentation
4.
Poignée
5.
Gâchette
6.
Capuchon de sûreté
7.
Orifice de remplissage
8.
Diffuseur de vapeur
Spécifications techniques
Tension:
120V., 60Hz.
Alimentation:
1,000 watts
Capacité en eau:
9 onces (260 ml)
*Les illustrations peuvent différer du produit lui-même.
23
9.
Adaptateur à angle
10.
Bec concentrateur
11.
Brosse pour petits objets
12.
Raclette à fenêtres
13.
Chiffon de nettoyage
14.
Boyau
15.
Tasse à mesurer
16.
Entonnoir
OPERATING INSTRUCTIONS
Upholstery
Use the steam diffuser with the cleaning cloth. Use fast, light strokes, avoid getting
the fabric wet. Be patient with stubborn spots; work on a spot gently for no more
than a minute at a time, then wait five minutes for the area to dry and repeat. Use
circular movements or back-and-forth and side-to-side movements to get all sides
of surface fibers. Finish with a brushing in one direction that will give the fabric a
uniform appearance.
CAUTION:
Always determine the color-fastness of any fabric - especially with reds
or blues - by taking a clean, moist, warm towel and gently rubbing a small area as
far down on the back or other out of the way place on the furniture as possible. If
color comes off on the towel, you may need to have the piece dry cleaned.
Window, Glass Surfaces and Mirrors
To use the window squeegee, work with the vapor jet down using the top to bottom
movements. To do this without leaving streaks, use lateral movements from the top
to the bottom of the surface.
Bathroom Areas
To clean the bathtub or shower area, use the small detail brush for grout, shower
door tracks, hard to get areas and heavily soiled areas. Allow plenty of time for the
heat to penetrate the surface. This is especially helpful in the shower area if there is
tile or grout.
To clean the toilet, use small detail brush. Use a terry cloth towel or paper towel to
wipe up excess moisture and residue.
To clean the sink and faucets, use small detail brush.
Soap Scum
Soap scum dissolves almost immediately under a combination of heat and moisture.
Rinse the surface with a small amount of water afterwards or go back over it once
more with a clean terry cloth towel.
Note:
Soap scum sometimes will develop a hard surface from waterborne minerals.
If this is the case, use the small detail brush first to break up this surface - or spray
or wipe first with lemon, vinegar or seltzer soda water to soften the minerals.
Moving too slowly can dry out the soap scum and cause it to granulate on the
surface. The surface will have a gritty feel. If this happens, apply vapor to the
surface with the small detail brush again and re-clean.
8
Publicité
Table des Matières
