Steba HC2 Hot&Cold Mode D'emploi page 22

Dismantling of the glass jug:
Don't be too powerful! Place the jug on a towel and hold it with
your right hand. With the left hand detach the heating element
with he attached dismantling help. Then clean both parts. Atten-
tion: blades are sharp! For the assembly, place the sealing joint
correctly into the heating element. Tighten the jug
heating element. Pay attention that the jug is fastened tightly
and dense.
usage:
∙ The appliance must not be plugged in during operation.
∙ Never try to insert the mixing insert without the glass jar into the appliance! Dan-
ger of injury!
∙ Wipe the motor base with a damp cloth, rinse the glass jar and dry all parts.
∙
Attention! Place the jug correctly on the motor element. The illuminated
arrow and the arrow on the jug need to be on top of each other. Please
make sure before turn on the device, that some liquid or fat is in
the jug.
∙ The complete assembled glass jar can be easily put on the motor base with a rotary
motion.
∙ Take care, that the mixing insert is always
screwed tightly to the glass jar, else a leaka-
ge can occur.
∙ When that happens, the appliance must be
switched off and dried instantly.
∙ If liquid ran into the appliance, the appliance
must be checked by an authorized service
person.
∙ By the first use, there might be a slight odor.
This is normal and fades after some use.
∙ use the appliance only if completely
assembled!
∙ The appliance must never be used wit-
hout food or liquids.
∙ Never use high proof or flammable liquids.
22
on the