Wear Parts - Oase BioSmart 5000 Notice D'emploi

- English -
Cleaning foam filters (cont.)
● Pull the handles of the foam filter holders through the slots in the inner cover from below until the foam filter
holders engage.
● Insert the inner cover into the filter container and fold over all clamps, fit filter cover and switch on the pump.
● Replace the foam filters if the float switch of the water level indicator keeps showing a medium to heavy soiling
following the cleaning process.
Cleaning the water level indicator
1. Turn the water level indicator counter-clockwise
through approx. 30° and pull out of the inner cover.
● Remove the plug and the float switch out of the
housing of the water level indicator and clean using
clear water.
● Reassemble in the reverse order such that the float
switch can move freely in the housing.
Storage/Winterization
● Put the unit out of operation at water temperatures below 46 °F (8 °C) or, at the latest, when freezing temperatures are
to be expected.
● Drain and thoroughly clean the unit, check for damage.
● Remove, clean, dry and store all filters in a frost-free environment
● Ensure that the storage place is inaccessible to children.
● Cover the filter container such that the ingress of rain water is excluded.
● Drain all hoses, pipes and connections as far as possible

Wear parts

Foam filters are wear parts and are excluded from the warranty.
Disposal
Do not dispose of this unit with domestic waste! Further information about the recycling of this product can be
obtained from your local municipal authority.
Troubleshooting
Issue Cause
Water stays cloudy Unit has been in operation only
for a short time
Inadequate pump capacity
Water extremely soiled
Foam filters soiled
Excessive fish and animal
population
1.
Solution
The complete biological cleaning effect is only achieved
after several weeks
Readjust the pump capacity
Remove algae and leaves from the pond, perform a partial
water change
Clean foam filters
Guide value: approx. 2 ft (60 cm) fish length on 1 m³ pond
water
6 6