Use With Dmx Controller - Renkforce 1374784 Notice D'emploi

Menu Overview
Display Option
Addr A001-A512
5CH-12CH
SOUN
AUtO SLou
FASt
NAnU P000-P255
t000-t255
r000-r255
G000-G255
b000-b255
rPAN NO-YES
rtLt NO-YES
rSEt NO-YES
LoAd NO-YES
dISP NO-YES
vEr
b) Use with DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 5 or 12 DMX channels depending on DMX operating mode.
Setting the DMX operating mode (channel number)
• Press MODE/ESC (1) repeatedly until Addr appears.
• Push the button ENTER (4) until 5CH or 12CH appears.
• Use the buttons UP (2) or DOWN (3) to select the desired DMX operating mode.
5CH = 5 channel DMX mode
12CH = 12-channel DMX operation
• Press the ENTER button (4) to confirm your input.
30
Explanation
DMX address setting
Selection of the DMX operating mode (channel number)
Sound-to-Light Mode
Automatic mode slow
Automatic mode fast
Setting the position PAN
Setting the position TILT
Brightness red
Brightness green
Brightness blue
Reversal of the direction of rotation for PAN
Reversal of the direction of rotation for TILT
Reset
Resetting to factory settings
Reversal of the display
Display of the Firmware Version