Display Of The Firmware Version; Master-Slave Mode; Handling - Renkforce 1374784 Notice D'emploi

k) Display of the Firmware Version
• Select vEr in the menu.
• Press the ENTER button (4) to display the current firmware version.
l) Master-Slave Mode
• Select the automatic or sound-to-light operation in the menu of the master unit.
• Set the DMX starting address at all slave devices to A001.
Only one device in a master-slave-chain must be defined as master device. All other devices
must be defined as slave devices (DMX starting address A001).

12. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold
to a warm environment. The resulting condensation may destroy the device. Allow the device to reach
room temperature before connecting it. Wait until the condensation has evaporated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the
intended grip areas.
• Always pull it from the socket using the intended grips.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never put any filter foils, masks or other materials over the light exit. This may cause heat damage and
danger of fire.
• The device may heat up during operation. Never touch the casing during operation. Let the effect light
cool off after operation before touching or cleaning the casing.
• Do not cover the device to ensure sufficient ventilation. Air circulation also must not be impaired by any
objects like magazines, tablecloths, curtains, etc. During operation, keep a minimum distance of 0.5 m
around the device.
34