Cembre B-TC0405 Notice D'utilisation page 5

–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––
FIG. 3
METAL CASE
COFFRET METALLIQUE
METALLKOFFER
ESTUCHE METÁLICO
CASSETTA METALLICA
NOTE
This hydraulic tool is powered by a 14.4 V battery.
The residual battery capacity level is automatically displayed after every cycle.
The part reference "B-TC0405 ; B-TC0405A" includes the following:
– Basic tool complete with battery
– Shoulder strap
– Spare battery
– Battery charger
– Carrying case type "VAL B-TC095"
2. INSTRUCTIONS FOR USE
The tool can be easily carried using either the handle or the shoulder strap (T) attached
to the rings (R).
2.1) Setting
Insert the conductor between the blades at the desired cutting point.
For a running conductor, remove the locking pin (39) and open the tool head.
Opening the upper blade must be done only when the tool is in rest position
(lower blade completely retracted).
With the conductor on the lower blade (36), close the tool head and fully insert the locking
pin (39).
Before carrying out further cutting operations make sure the locking pin is com-
pletely inserted: a partial insertion may damage the tool head.
2.2) Blade advancement
Press operating button (06) to activate the motor-pump group for the advancement of
the lower blade (36). To halt the advancement, release the operating button (06) and the
motor will cut out.
2.3) Cutting
Continue operating the button (06) to gradually move the lower blade to cut through the
conductor.
The motor will continue to operate after the maximum pressure relief valve has activated.
No further cutting force is applied, the oil is bypassed and returned to the reservoir.
2.4) Blade retraction
By pressing the pressure release button (201) on the body of the tool below operating
button (06), the ram will retract, opening the blades.
35 4
(Ref. to Fig. 1)
ENGLISH