Installation Of The Waste Water Hose; Raised Level Installation - Pkm DW12-6FI Mode D'emploi

Masquer les pouces Voir aussi pour DW12-6FI:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.7 Installation of the waste water hose

If the drainage hose is longer the 4 m. the dishes will not be cleaned properly.
Check that the connection does not leak. Fix the outlet hose with a hose-holder.
NOTICE! After the installation of the water supply and wastewater disposal
as well as before the first operation, all water hose connections – even on
the appliance itself – must be checked for leakage. The manufacturer is
not liable for any damage caused by improper installation.

2.8 Raised level installation

Partially and fully integrated appliances can be installed at a raised level when
connected properly.
❖ A collar enables the bending of the drain hose. There is a holding device on the
collar to fix the collar. The drain hose must have a height of min. 40 cm at the
top of the collar. Look at the drawing below for the connection options A, B and
C.
Fit the drainage hose of your
appliance to the drainage pipe
without bending.
If the length of the hose is not
sufficient, apply to your
authorised
extension made from the same
material as the original hose.
Remember that the length of
the hose (including extension)
should not exceed 4 meters.
~
~
62
service
for
an

Publicité

Table des Matières
loading

Table des Matières