Unpacking And Positioning; Before Installation - Pkm DW12-6FI Mode D'emploi

2.1 Unpacking and Positioning

1. Unpack the appliance carefully. Completely remove the transport-protection. Be
very careful and do not use any aggressive or abrasive detergents to remove
residuals of the transport-protection.
2. The spray arms may be equipped with a transport protection. Remove the
transport protection before installing the appliance.
3. Install the appliance in a dry and well-ventilated place.
4. Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
5. Connect the appliance to the mains properly.
6. The nameplate is inside the appliance or at the back.

2.2 Before installation

I
1. You must install the condensation strip on the bottom side of the worktop to
protect it from the water vapour released by the appliance. The condensation strip
deflects the water vapour from the worktop.
2. You will find the condensation strip inside your appliance.
3. Clean the bottom side of the worktop properly before you install the
condensation strip.
4. Remove the protective foil from the adhesive surface of the condensation strip.
5. Stick the condensation strip on the bottom side of the worktop.
NOTICE! Improper installation of the condensation strip may cause
damage to the worktop.
❖ Required space for the appliance: look at the following figures. The back of the
appliance must face the wall. The appliance must be equipped with an inlet and
outlet hose, which can be installed on the left or right.
4
Eqiupment depends on model.
NSTALLATION OF THE CONDENSATION STRIP
(D
EPENDING ON MODEL
)
C
ONDENSATION STRIP
~ ~
57
.
.
4