Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
a: hexagon screwdriver /CR-V 4 mm
2.7 Installation of the water inlet hose
Connect the inlet hose to a connector with a 3/4
inch thread firmly and securely. When the hoses are
new or were not used for an extended period of
time, let the water flow until the hose is clear of any
contamination.
NOTICE! Otherwise the water inlet may be
blocked and the appliance will be damaged.
2.8 Installation of the waste water hose
Fit the drainage hose of your
appliance to the drainage pipe
without bending.
If the length of the hose is not
sufficient, apply to your
authorized
extension made from the same
material as the original hose.
Remember that the length of the
hose (including extension) should
not exceed 4 meters.
51
service
for
an
Publicité
Chapitres
Table des Matières
