afx light FOG COLOR RGB Manuel D'utilisation page 8

On the following table, you will see DMX channel function
CHANNEL FUNCTION
CHANNEL 1
RED COLOR
CHANNEL 2
GREEN COLOR
CHANNEL 3
BLUE COLOR
CHANNEL 4
COLOR MIXING
CHANNEL 5
AUTO SPEED
CHANNEL 6
STROBE
CHANNEL 7
DIMMER
CHANNEL 8
3. Low fluid protection
This machine use electronic program to detect whether there is fluid inside tube or not, hence to protect the pump
from being damaged when there is no fluid.
1. How to activate "low-fluid protection"
when the internal inspection module check out there is no oil inside the tube but the machine is still working,
then the machine will get into oil free protection 20s later by shutting the pump off. The digital display will keep
flashing.
2. How to release "low-fluid protection"
When the machine is under the protection of low fluid, after refilling the fluid, there are two ways to release the
protection.
a). Under the wireless remote control, keep pressing any buttons until the fog liquid fill the tube completely,
then the machine would exit low-fluid protection.
b). Under the DMX control, firstly push the slider of channel one to the value below 10 (Fog OFF),then
push the slider up to value above 10(Fog ON), the machine would exit low-fluid protection by doing so.
Note: When the machine is heating up. HEAT page is prior to ADDR and all the other pages. Without connecting
with DMX, the digital display will back to page ADDR automatically.
CLEANING AND USING FREQUENCY OF PRODUCT
Please clean the fog machine periodically in order to keep it in good condition.
1- The fog liquid should be clear and not polluted. The bottle cap should be screwed tightly after filling in of the fog
liquid.
2- When the fog machine worked 40 hours continuously, please use 80% of distilled water and 20% of white
vinegar to clean the impurities which accumulated inside the heating tube
3- Remove the nozzle before the fog machine is warming up. Use vinegar to clean it and keep clear
4- Pour out the fog liquid and fill the tank with the distilled water/vinegar mix as above. Switch on the power and the
machine will warm up.
5- Operate the fog machine at open place until the distilled water/vinegar mix has been used up. Fill the unit again
with fog liquid and operate it at an open place until the vinegar smell has disappeared.
© Copyright LOTRONIC 2016
DMX
0-9
FOG
10-255
0-9
10-255
0-9
10-255
0-9
10-255
0-9
10-255
0-9
10-255
0-9
10-255
0-9
10-255
DESCRIPTION
No fog
Fog on
No function
0%-100%
No function
0%-100%
No function
0%-100%
No function
Color mixing
No function
Speed of color mixing ( from slow to fast )
No function
Strobe ( from slow to fast )
No function
0% - 100%
FOG COLOR RGB Page 8