Battery Installation; Important Recycling Advice - Petsafe PTY19-17327 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
Hereinafter Radio Systems Corporation, Radio Systems PetSafe Europe Ltd., Radio Systems Australia Pty Ltd. and any other affiliate or
Brand of Radio Systems Corporation may be referred to collectively as "We" or "Us".
IMPORTANT SAFETY INFORMATION
Explanation of Attention Words and Symbols used in this product manual
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible injury or death.
CAUTION, used with the safety alert symbol, indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
CAUTION, used without the safety alert symbol, indicates a hazardous situation which, if not avoided,
could result in harm to your pet.
NOTICE, is used to address safe use practices not related to personal injury.
CLASS 1 LASER PRODUCT
< 390 uW max output at 650 nm
Complies with: IEC/EN 60825-1:2014
And CDRH Rule 21 CFR, Subchapter J
LASER RADIATION. Risk of exposure.
Laser radiation is emitted from this product. Please read all safety labels affixed to the product.
Do not look into the laser beam or the laser beam reflection.
Do not aim the laser beam at a person.
Avoid direct eye contact with the laser beam. If exposed, close eyes immediately and divert eyes
away from laser beam.
Changes to the laser equipment are not permitted.
Follow the instructions provided in the Product Manual. Use of controls or adjustments or performance of
procedures other than those specified herein may result in hazardous radiation exposure.
Keep away from children.
Not intended as a toy for children.
Do not allow small children to use this product to play with your pet without adult supervision.
Do not aim the laser beam directly into the eyes of a pet.
Supervise pet while playing with this product.
If you notice your pet exhibiting unusual behaviour, immediately discontinue use of product.
Consult with a veterinarian before resuming use of product.
Do not place the toy on any surface other than a flat, level floor.
Inspect this product periodically for damage and discard product immediately if it appears worn
or broken.
Do not mix old and new batteries.
Do not mix standard, alkaline or rechargeable batteries.
Do not use rechargeable batteries. If rechargeable batteries are used, they must be removed from
the toy prior to recharging, and must only be charged under adult supervision.
Exhausted batteries should be removed immediately. Do not dispose of batteries with household
waste.
Non-rechargeable batteries are not to be recharged
Batteries are to be inserted with correct polarity
The supply terminals are not to be short-circuited
These instructions and the product packaging must be retained and
passed on with ownership. They contain important information.
2
petsafe.com
Toy Assembly
No assembly is required. Simply install batteries, press power button and place the Laser Tail toy on the ground to use. Do not place
the toy on any surface other than a flat, level floor.
The Laser Tail toy may not work on all surfaces.
If you have questions about the Laser Tail toy or any of our products, please contact the Customer Care Centre for further information.
For a listing of Customer Care Centre telephone numbers, visit our website at petsafe.com.

Battery Installation

1.
Remove the battery door which is located on the bottom of the toy (A).
2.
Insert 3, AA batteries into the battery compartment (B).
3.
Replace the battery door and ensure it is closed properly.
Operating Instructions
The Laser Tail toy moves around the floor in a random motion, displaying a single laser behind it for 10 minutes, then automatically
powers off.
Place the toy on the floor.
Make sure the floor surface is flat and even.
Press and release the power button located on the bottom of the toy to turn on power (C)
The toy will activate and make one beep noise.
The toy will roll around the floor randomly.
The toy will automatically turn off after 10 minutes
If you wish to end the play session before the toy automatically turns off, press the power button one time.
Advice for use
Apart from playing with this product, it is recommended that pet parents interact with their pets and provide a variety of play activities,
opportunities for stimulation and appropriate amount of daily exercise as determined by their veterinarian.

Important Recycling Advice

Please respect the Waste Electrical and Electronic Equipment regulations in your country. This equipment must be recycled.
If you no longer require this equipment, do not place it in the normal municipal waste system. Please return it to where it was
purchased in order that it can be placed in our recycling system. If this is not possible, please contact the Customer Care Centre for
further information. For a listing of Customer Care Centre telephone numbers, visit our website at petsafe.com.
Compliance
IC: Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
CE: Europe
Radio Systems Corporation declares under its own responsibility, that the following product(s) is (are) in compliance with the
essential requirements under the EMC Directive 2014/30/EU, and the RoHS 2 Directive (EU) 2015/863 Unauthorised changes or
modifications to the equipment that are not approved by Radio Systems Corporation may violate EU EMC regulations, could void the
user's authority to operate the equipment and will void the warranty. Hereby, Radio Systems Corporation, declares that this part is in
compliance with the essential requirements and other relevant provisions. The Declaration of Conformity can be found at: http://www.
petsafe.com/customercare/eu_docs.php.
petsafe.com
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pty17-16454

Table des Matières