Reverting To The Factory Settings; Technical Data - diagral DIAG56AAX Guide D'installation

6. Reverting to the factory settings

1. Disconnect the box from mains socket (for at least 10s).
2. After removing the flap, push down the button located at the back of the box.
3. Connect to mains socket, and hold the button down until the light indicator (green/orange) flashes.
w Release the button.
The box was returned to the factory settings, and is no longer operating in the installations.

7. Technical data

Technical data
Indicator light
Power supply
Max. power
Ethernet port
Radio link
Operating temperature
Average humidity rate
Environment
Degree of protection
Use
Dimensions (H x W x D)
Weight
Description of symbols
The product complies with fundamental
requirements for safety, health and
environmental protection.
Ethernet network (ADSL) cable
Waste processing of electrical and electronic devices at the end
of their service life (Applicable in European Union countries and
other European countries with a waste collection system). Used on
products or product packaging, this symbol indicates that the
product must not be thrown out with household waste. It must be taken to
a waste collection point for electrical and electronic product recycling.
When you make sure that this product is disposed of in the most appro-
priate manner, you are helping to protect the environment and human
health. If you would like additional information concerning the recycling of
this product, please contact your town/city council, nearest waste collec-
tion centre or the shop where you bought the product.
We appreciate your suggestions
If you have any remarks about how we may improve our guides and our products, please
pass them on to us by post or by e-mail (assistancetechnique@diagral.fr) specifying the
date on which you purchased the equipment. Thank you.
To obtain advice when installing your system or before returning equipment, please contact
the Diagral technical support team on:
A team of qualified technicians will tell you what to do. You will find the answers to the most
frequently asked questions together with the main technical manuals on our web site:
www.diagral.be.
1 three-coloured green, red and orange indicator light
1 RXU13X adapter
(100-240 VAC 50-60 Hz 0.03 A/5 VDC – 1 A)
5 W
RJ45 10/100 Base-T
433,05 - 434,790 MHz, 10 mW max
duty cycle: 10%, Rx: category 2
868 - 870 MHz, 25 mW max
duty cycle: 0,1%, Rx: category 2
0°C to + 40°C
from 5% to 75% without condensation at 25°C
maximum altitude: 2 000 meters
IP30 / IK02
inside premises
122 x 163 x 34 mm
235 g
+33 476 928 326
current rates apply
DIAG56AAX alarm and control box
The note must absolutely be consulted before
installation, use and maintenance of the
equipment
Direct current symbol
Hager Security SAS hereby declares that
the radioelectric equipment, reference(s)
DIAG56AAX, complies with the
requirements of the following
2014/53/EU RE-D directive.
The full text of the EU Declaration of
Conformity is available at the address
www.diagral.com.
Non-binding document,
subject to modification
without notice.
15