Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
INTRODUCTION
MANUAL PURPOSE AND CONTENTS
The purpose of this Manual is to provide the Operator with all
necessary information to use the machine properly in a safe
and autonomous way. It contains information about technical
characteristics, operation, machine storage, maintenance,
spare parts and safety conditions.
Before carrying out any procedure on the machine, the
Operators and qualified Technicians must read this Manual
carefully. Contact Nilfisk-Advance in case of doubts regarding
the interpretation of the instructions and for any further
information.
TARGET
This Manual is intended as a guide for both the Operator and
the qualified Technicians.
The Operators must not carry out operations reserved for
qualified Technicians. Nilfisk-Advance will not be answerable
for damages coming from the non-observance of this
prohibition.
HOW TO KEEP THIS MANUAL
The User Manual must be kept near the machine, inside an
adequate case, away from liquids and other substances that
can cause damage to it.
CONFORMITY CERTIFICATE
Figure A shows the documentation certifying the machine
conformity with the law in force.
IDENTIFICATION DATA
The machine model and serial number are marked on the
plate on the tank and can be read from the outside (1, Fig. C).
The machine model year is written in the EC statement and it
is also indicated by the first two figures of the machine serial
number.
This information is useful when ordering machine and engine
spare parts. Use the following table to write down the
machine identification data for any further reference.
MACHINE model ...........................................................
MACHINE serial number ...............................................
2
OTHER REFERENCE MANUALS
Electronic Battery Charger Manual, if equipped, which is to be
considered an integral part of this Manual.
Moreover, the following manuals are available:
–
Service Manual (that can be consulted at
Nilfisk-Advance Service Centers).
–
Spare Parts List (supplied with the machine).
SPARE PARTS AND MAINTENANCE
All necessary operating, maintenance and repair procedures
must be carried out by qualified personnel or by
Nilfisk-Advance Service Centers. Only original spare parts
and accessories must be used.
Call Nilfisk-Advance for service or to order spare parts and
accessories, specifying the machine model and serial
number.
CHANGES AND IMPROVEMENTS
Nilfisk-Advance constantly improves its products and
reserves the right to make changes and improvements at its
discretion without being obliged to apply such benefits to the
machines that were previously sold.
Any change and/or addition of accessory must be approved
and performed by Nilfisk-Advance.
909 5319 000(3)2005-01 A
Publicité
Chapitres
Dépannage
