Pushing/Towing The Machine; Machine Long Inactivity; First Period Of Use; Maintenance - Nilfisk Advance BA 600S Manuel D'emploi Et D'entretien

PUSHING/TOWING THE MACHINE

When it is not possible to use the machine drive, to push/tow
the machine easily it is necessary to activate the drive cut-off
switch (36, Fig. C).
When the pushing/towing is over, reset the drive by means of
the switch (36, Fig. C).

MACHINE LONG INACTIVITY

If you foresee that the machine will not be used for more than
30 days, proceed as follows:
1. Perform the operations described in the paragraph After
Using The Machine.
2. Disconnect the battery red connector (30, Fig. C).

FIRST PERIOD OF USE

After the first period of use (first 8 hours) it is necessary to
carry out the following operations:
– Check the fixing and connecting parts for proper
tightening;
– Check the visible parts for integrity and leakage.
909 5319 000(3)2005-01 A

MAINTENANCE

The lifespan of the machine and its maximum operating
safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The
intervals shown may vary according to particular working
conditions, which are to be defined by the person in charge of
the maintenance.
WARNING!
The operations must be carried out with the
machine off and the battery disconnected.
Moreover, read carefully the instructions in the
Safety chapter before performing any
maintenance operation.
All scheduled or extraordinary maintenance operations must
be performed by qualified personnel, or by an authorised
Service Center.
This Manual contains the Scheduled Maintenance Table and
describes only the easiest and most common maintenance
procedures.
NOTE:
For other maintenance procedures contained
in the Scheduled Maintenance Table or for
extraordinary maintenance operations see the
specific Service Manual that can be consulted
at any Service Center.
USER MANUAL
13