Technical Data - Elem Garden Technic CBE5530T Traduction Des Instructions D'origine

USING THE TRIMMER AS AN EDGER
Before making this change,
make sure that the device
is switched off and
completely separated from
For edging driveways and paths, transform the
trimmer from trimmer mode to edging mode
as follows:
Push the adjusting button (12) on the motor
housing and then rotate the housing to the
edge position.
Release the adjusting button, ensure the
motor housing section firmly clicks to secure in
place as it audibly snaps into position.
Now the trimmer can be used as an edge
trimmer.
Warning: To prevent
accidental starts which may
cause serious personal
injury, always disconnect
the power cord before
attempting to rotate the
MAINTENANCE
maintenance to the machine,
always unplug the machine.
Regular cleaning and maintenance of you grass

trimmer will ensure efficiency and prolong the
life of your machine.
After each cutting operation, take apart and

clean out the grass and soil from; the spool and
its slot, the whole trimmer and in particular the
guard.
During operation, keep the air slots clean and

free of grass.
Only use a cloth soaked with hot water and a

soft brush to clean the grass trimmer.
Do not spray or wet the appliance with water.

Do not use detergents or solvents as these

could ruin the trimmer. The parts in plastic can
easily be damaged by chemical agents.
If the line cutting blade no longer cuts or breaks,

have this replaced by contacting an authorized
service centre.
For repairs which have not been explained in

these instructions, contact an authorized
service centre.
After use, disconnect the machine from the

mains and check for damage;
the power mains.
shaft.
Before performing
When not in use store the machine out of the

reach of children;
Inspect and maintain the trimmer regularly.

Mains powered trimmers should only be
repaired by an authorized repairer ;
User may carry out maintenance and

adjustments. Please refer to the part of
REPLACEMENT OF THE SPOOL OF NYLON
WIRE.
Use only manufacturers

replacement parts and accessories. (Line:φ
1.6 )
TROUBLE-SHOOTING
maintenance to the machine,
always unplug the machine.
If the grass trimmer vibrates: remove the spool

and clean its slot carefully removing any grass
and so forth. If vibration persists after
reassembly, replace the spool with a new one.
In the event of the problem not disappearing,
have the trimmer checked at an authorized
service center.
If the grass trimmer does not start: check all the

electrical connections; make sure the safety
circuit-breaker has not been activated; check
that no fuse has blown in your electrical system.
If after the above checks, the grass trimmer still
dose not start, have it checked at an authorized
service center.
STORAGE
Follow these recommendations for storing the grass
trimmer:
Carry out general cleaning of the grass

trimmer and its ancillary parts (see
maintenance paragraph), the prevents mould
from forming.
Store it out of the reach of children, in a stable

and safe position and in a dry place where the
temperature is not too hot or too cold.
Store the trimmer away from direct sunlight, if

possible in a dark or barely lit place.
Do not store in a nylon bag as this could

encourage the formation of damp patches.
Do not store the grass trimmer resting on the

floor. Hang it by the upper handgrip instead, so
that the guard does not touch anything. The
resting of the guard on a surface could alter its
shape and therefore its dimensions and safety
characteristics would be modified.

TECHNICAL DATA

Mains voltage
Mains frequency
Power input
No load speed
Max. cutting circle
Weight kg
recommended
Before performing
230-240 V~
50 Hz
550 W
-1
n :10000 min
0
30 cm
2.291 kg
27