Technical Data; Service Department - Elem Garden Technic CBE25020 Traduction Des Instructions D'origine


Use only manufacturers
replacement parts and accessories. (Line:φ
1.2 )
TROUBLE-SHOOTING
maintenance to the machine,
always unplug the machine.

If the grass trimmer vibrates: remove the spool
and clean its slot carefully removing any grass
and so forth. If vibration persists after
reassembly, replace the spool with a new one.
In the event of the problem not disappearing,
have the trimmer checked at an authorized
service center.

If the grass trimmer does not start: check all the
electrical connections; make sure the safety
circuit-breaker has not been activated; check
that no fuse has blown in your electrical system.
If after the above checks, the grass trimmer still
dose not start, have it checked at an authorized
service center.
STORAGE
Follow these recommendations for storing the grass
trimmer:

Carry out general cleaning of the grass
trimmer and its ancillary parts (see
maintenance paragraph), the prevents mould
from forming.

Store it out of the reach of children, in a stable
and safe position and in a dry place where the
temperature is not too hot or too cold.

Store the trimmer away from direct sunlight, if
possible in a dark or barely lit place.

Do not store in a nylon bag as this could
encourage the formation of damp patches.

Do not store the grass trimmer resting on the
floor. Hang it by the upper handgrip instead, so
that the guard does not touch anything. The
resting of the guard on a surface could alter its
shape and therefore its dimensions and safety
characteristics would be modified.

TECHNICAL DATA

Mains voltage V
Mains frequency Hz
Power input W
No load speed min-1
Max. cutting circle mm
Weight kg
Acoustic pressure level
LpA 83.7 dB(A)
Acoustic power level
LwA 96 dB(A)
recommended
Before performing
230
50
250
13500
200
1.5
K = 2.5 dB(A)
K = 3 dB(A)
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard. : 6.532 m/s²
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).

SERVICE DEPARTMENT

_ Damaged switches must be replaced by our after-
sales service department.
_ If the power cable is damaged it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
After-sales Service and Application Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product
as well as spare parts. Exploded views and
information on spare parts can also be found
under:www.eco-repa.com
ELEM GARDEN TECHNIC application service team
will gladly answer questions concerning our
products and their accessories : sav@eco-repa.com
STORAGE
_ Thoroughly clean the whole machine and its
accessories.
_ Store it out of the reach of children, in a stable and
secure position, in a cool and dry place, avoid too
high and too low temperatures.
_ Protect it from exposure to direct sunlight. Keep it
in the dark, if possible.
_ Don't keep it in plastic bags to avoid humidity
build-up.
ATTENTION !
must be worn.
K= 1.5 m/²
21