IMG STAGELINE RGBL-430DMX Mode D'emploi page 14

6.1 Power supply of multiple units
GB
The mains feed-through output allows to supply
additional RGBL-430DMX (or other units) with
power: Connect the grey PowerCon
PUT of the first unit to the blue PowerCon
INPUT of the second unit: Use a mains cable with
PowerCon ® plugs (NAC-3FCB and NAC-3FCA).
The second unit can be connected to the third unit
etc. until all units have been connected in a chain.
WARNING When multiple units have been inter-
connected for power supply, the total
current consumption of all units must
not exceed 16 A; otherwise, overload
may cause short circuit and fire.
Therefore, a maximum of 28 units of
the type RGBL-430DMX may be
interconnected. With a current load
of 16 A, also make sure that all mains
cables used are designed for this
load.
7 Operation
WARNING To prevent damage to your eyes,
never look directly into the light
source for any length of time.
Please note that fast changes in light-
ing may trigger epileptic seizures
with photosensitive persons or per-
sons with epilepsy!
To switch the unit on and off, use the switch
POWER (3). The unit is operated via a menu by
means of four buttons and a display (5): please
refer to chapter 7.1. Figure 2 shows the menu
structure.
Operation with a DMX controller
Use the menu item
nel mode and to set the DMX start address. If
required, use the menu to set additional functions
(e. g. behaviour of the unit after loss of the control
signal). The light effect unit will be set to operation
via the DMX controller when the menu item
DMXSETUP
is selected. (If the unit does not receive
any DMX control signal, the display will flicker.) All
DMX functions can be found in the tables in chap-
ter 9.
14
® jack OUT-
DMXSETUP
to select the chan-
Operation without DMX controller
When the unit is operated on its own, set an auto-
matic or music-controlled show program (menu
PROGRAM
item
corresponding menu items
® jack
cific lighting colour. If required, use the menu to set
additional functions (e. g. total brightness via menu
SETUPDIM
item
For the master/slave mode (
the master unit to an automatic or music-controlled
show program and select the setting
MASTER
menu item
DMXSETUP
menu item
slave unit does not receive any DMX control signal
from the master unit, the display will flicker.)
7.1 Operation of the menu
The display time is adjustable (
item ).
12
1) To select a menu item, use the button MENU or
UP or the button DOWN.
2) To change the setting for the menu item
selected:
a) Press the button ENTER (setting starts flash-
ing on the display).
b) Use the button UP or DOWN to change the
setting.
c) To save the setting, press the button ENTER
(setting stops flashing).
When two settings are provided for a menu item
(e. g. for menu item
ting will start flashing on the display when the
first setting has been saved. To change the set-
ting, use the button UP or DOWN; to save the
setting, press the button ENTER.
No setting is provided for the menu items
VERSION
indicate the firmware version and the tempera-
ture inside the unit.
Via the menu item
factory settings when the button ENTER is
pressed.
SOUND
or ). Alternatively, use the
COLORSET
).
chapter 5.2), set
. On the slave units, select the
and set it to
PROGRAM
), the second set-
LED PCB
and ; they are only used to
RESET
, the unit is reset to its
to set a spe -
ON
for the
SLAVE
. (If the
chapter 7.1.1,