Saving, Displaying And Deleting Measured Values - Beurer medical BM 40 Mode D'emploi

ing the measurement. If the icon
contact your doctor. Any self-diagnosis and treatment based
on the test results may be dangerous. It is vital to follow your
doctor's instructions.
WHO classification:
In accordance with the guidelines/definitions of the World
Health Organization and the latest findings, the measurements
can be classified and assessed according to the following table.
Range of blood pressure values
Grade 3: Severe hypertension
Grade 2: Moderate hypertension
Grade 1: Mild hypertension
High-normal
Normal
Optimal
Source: WHO, 1999
The bar graph in the display and the scale on the unit indicate
the range of the blood pressure which has been recorded.
If the values for systolic and diastolic pressure are in two dif-
ferent WHO ranges (e.g. systolic in the high-normal range and
diastolic pressure in the normal range) the graphic WHO clas-
sification on the unit indicates the higher range (high-normal in
the example described).
appears often, please
Systolic (in mmHg) Diastolic (in mmHg)
> = 180 > = 110
160 – 179 100 – 109
140 – 159 90 – 99
130 – 139 85 – 89
120 – 129 80 – 84
< 120 < 80
However, these standard values serve only as a general guide-
line, as the individual blood pressure varies in different people
and different age groups etc.
It is important to consult your doctor regularly for advice. Your
doctor will tell you your individual values for normal blood pres-
sure as well as the value above which your blood pressure is
classified as dangerous.
Measure
Seek medical advice
Seek medical advice
Have it checked regularly by doctor
Have it checked regularly by doctor
Check it yourself
Check it yourself
7. Saving, displaying and deleting measured
values
The results of every successful measurement are stored
together with the date and time. If there are more than 60
measurements, the oldest measurements are lost.
• Select the desired user memory (
the SET button and the function buttons -/+
your selection with the START/STOP button
20
) by pressing
-/+. Confirm
.