Helios MiniVent M1/100 P Notice De Montage Et D'utilisation page 30

Installation and Operation Instructions
UK
MiniVent M1/100/120 P
– Duct inside diameter M1/100 P = 100 mm or M1/120 P = 120 mm
and distance to room corners: at least 90 mm.
– With regard to surface mounted cabling, the side entry knockout for the cable (fig.9, Pos
broken out!
– The connection cable and the control line must be stored so that no water can get in along the cable in case of wa-
ter exposure. The cables must not be placed over sharp edges!
fig.6
Cable exit
possible as
required in
dark area
min. 90 mm
*
Type M1/120..
2. Drill holes:
Set casing against the wall, mark the holes and drill. Fasten with at least 2 screws and plugs.
3. Back draught shutter and guide van
– When installing the device, the guide vane must be mounted vertically (fig. 8).
Snaps into place every 90° rotation.
– Affix the rubber foam (scope of delivery) before final assembly (fig.8)
fig.8
When installing the device, the gui-
š
de vane must be mounted verti-
cally (as depicted). Snaps into place
every 90° rotation.
top
š
bottom
vertical for wall installation
fig.7
Recommen-
ded cable
Cable routing under the casing. Cable
exit optional
length from wall at least
0...-360 °,
180 mm.
ideally 45°
drill holes
fig.9
Affix the rub-
ber foam
Œ
Back dr-
aught
Œ
Break out entry
›
shutter
knockout for cable for
removable
wall mounting
š
Guide vane

Condensate drain holes for
removable
ceiling suspension.
8
Π) in the casing must be


Ž