Setting The Display Brightness; Aux Connection - Beurer WL 75 Mode D'emploi

8.7 Setting the Display Brightness

NOTE: The Wake-up Light has four display brightness levels (0, 1, 2, and 3). You can set the display brightness
in the settings of the 'beurer LightUp' app or use the buttons on the Wake-up Light.
To set the display brightness using the buttons on the Wake-up Light:
1. Press the Set button on the device four times. 'SET Display' appears on the display. Wait three seconds
until a number flashes on the display.
2. Use the / buttons to set the desired display brightness. Confirm with the Set button. The selected
brightness is shown after five seconds.
Alternatively, you can also tap on the right-hand side of the display to temporarily increase brightness.

8.8 AUX Connection

You can connect an external audio source (e.g. MP3 player, smartphone or CD player) to the Wake-up light
via the AUX input.
1. Connect the included AUX cable to your audio source.
2. Insert the other end of the AUX cable into the AUX input on the rear of the device.
3. Press the AUX button on the device. The external audio source is now connected.
4. Use the / buttons to adjust the volume.
5. Press the AUX button to exit AUX mode again.
8.9 Switching the Button Tone On/Off
You can only switch the button tone of the Wake-up Light on and off via the settings in the 'beurer LightUp'
app.
8.10 Activating/Deactivating Bluetooth
NOTE: The Wake-up Light comes with Bluetooth
Wake-up Light cannot connect to the 'beurer LightUp' app.
To deactivate Bluetooth
1. Press the Set button on the device five times. 'SET
' ' flashes on the display.
on
2. Press the or button until 'OFF' appears In the display. Confirm with the Set button. Bluetooth
now deactivated.
on the Wake-up Light:
®
®
®
already activated. If you deactivate Bluetooth
' appears In the display. Wait three seconds until
8
, the
®
is
®