Noise/Vibration Information - Bosch PST 700 E Notice Originale

14 | English
Jigsaw
Weight according to EPTA-Procedure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-
specific models.

Noise/vibration information

Noise emission values determined according to EN 62841-2-11.
Typically, the A-weighted noise level of the power tool is:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection
Total vibration values a (triax vector sum) and uncertainty K determined according to EN 62841-2-11:
h
Cutting boards with saw blade T 144 D:
a
h,B
K
Cutting sheet metal with saw blade T 118 A:
a
h,M
K
The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure detailed in EN 62841
and may be used to compare power tools. They may also be
used for a preliminary estimation of vibration and noise
emissions.
The given vibration level and noise emission value represent
the main applications of the power tool. However, if the
power tool is used for other applications, with different ap-
plication tools or is poorly maintained, the vibration level
and noise emission value may differ. This may significantly
increase the vibration and noise emissions over the total
working period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and application tools, keeping the hands warm,
and organising workflows correctly.
Fitting
Pull the plug out of the socket before carrying out any
u
work on the power tool.
1 609 92A 49Y | (18.09.2018)
PST 700 E
kg 1.6
/II
PST 700 E
dB(A) 88
dB(A) 99
dB 3
2
m/s 10
2
m/s 3
2
m/s 11
2
m/s 3
Inserting/changing the saw blade
When fitting or changing the saw blade, wear protect-
u
ive gloves. Blades are sharp and can become hot when
used for prolonged periods of time.
Selecting the saw blade
You will find an overview of recommended saw blades at the
end of these operating instructions. Only use saw blades
with a single lug shank (T shank) or with a 1/4" universal
shank (U shank). The saw blade should not be longer than
required for the intended cut.
Use a narrow saw blade when sawing tight curves.
Inserting the saw blade (see figures A and E)
Clean the shaft on the saw blade before inserting it.
u
A dirty shaft cannot be securely fixed in place.
Push the saw blade receptacle (13) upwards in the direction
of the arrow. Push the saw blade (8), with the teeth in the
cutting direction, into the saw blade receptacle as far as it
will go.
Make sure when inserting the saw blade that the back of the
saw blade is in the groove on the guide roller (7).
Precise cuts are only possible if the guide roller (7) fits
closely – but not too tightly – against the back of the saw
blade (ensure that the saw blade (8) is not bent by the guide
roller). If necessary, loosen the screw (17) and slide the
bracket (16) for the guide roller so that the guide roller fits
closely against the back of the saw blade. Retighten the
screw (17).
PST 7000 E PST 7200 E
1.6 1.6
/II /II
PST 7000 E PST 7200 E
88 88
99 99
3 3
10 10
3 3
11 11
3 3
Bosch Power Tools