Product Description And Specifications; Intended Use; Product Features; Technical Data - Bosch PST 700 E Notice Originale

Always wait until the power tool has come to a com-
u
plete stop before placing it down. The application tool
can jam and cause you to lose control of the power tool.
Use only undamaged saw blades that are in perfect
u
condition. Bent or dull saw blades can break, negatively
influence the cut, or lead to kickback.
Do not brake the saw blade to a stop by applying side
u
pressure after switching off. The saw blade can be dam-
aged, break or cause kickback.
Use suitable detectors to determine if utility lines are
u
hidden in the work area or call the local utility com-
pany for assistance. Contact with electric lines can lead
to fire and electric shock. Damaging a gas line can lead to
explosion. Penetrating a water line causes property dam-
age or may cause an electric shock.
Products sold in GB only:
Your product is fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an au-
thorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.

Technical data

Jigsaw
Article number
Cut Control
Stroke rate control
Rated power input
Power output
No-load stroke rate n
0
Stroke
Max. cutting depth
– in wood
– in aluminium
– in steel (unalloyed)
Max. cutting angle (left/right)
Bosch Power Tools

Intended use

The power tool is intended for making separating cuts and
cut-outs in wood, plastic, metal, ceramic plates and rubber
while resting firmly on the workpiece. It is suitable for
straight and curved cuts with mitre/bevel angles of up to
45°. Note the saw blade recommendations.

Product features

The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) On/off switch locking mechanism
(2) On/off switch
(3) Dust extraction hose
(4) Extraction outlet
(5) Base plate
(6) Sawdust blower device switch
(7) Guide roller
A)
(8) Saw blade
(9) Viewing window for Cut Control
(10) Base for Cut Control
(11) Shock protection guard
(12) Handle (insulated gripping surface)
(13) Saw blade receptacle
(14) Anti-splinter guard
(15) Accessory holder
(16) Bracket for guide roller
(17) Screw
(18) Scale for mitre angles
(19) Cut mark 0°
(20) Cut mark 45°
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
PST 700 E
3 603 CA0 0..
●
●
W 500
W 300
–1
min 500–3100
mm 20
mm 70
mm 10
mm 4
° 45
English | 13
A)
A)
A)
A)
PST 7000 E PST 7200 E
3 603 CA0 0.. 3 603 CA0 0..
●
●
500 500
300 300
500–3100 500–3100
20
70
10
4
45
1 609 92A 49Y | (18.09.2018)
●
●
20
72
10
4
45