Viewing System Information; Stand-Alone Mode - HQ Power ARAS 3610 Mode D'emploi

Smooth Dimming
You can use normal or smooth dimming. Smooth dimming diminishes the slight flicker that may appear with
normal dimming.
1. In the main menu, press [Setup].
2. Select [Fader Delay] and press [Enter].
3. Set to [ON] for smooth dimming and press [Enter]. Set to [OFF] for normal dimming.
Temperature Warning
The device can show a warning on the display if the LED temperature exceeds a certain value. This allows you
to extend the lifetime of the LEDs.
To display a temperature warning, proceed as follows:
1. In the main menu, press [Setup].
2. Select [Temp Switch Set] and press [Enter].
3. Set to [ON] and press [Enter].
4. Select [Temperature Set] and press [Enter].
5. Set the threshold temperature (50-120 °C) at which the warning has to appear on the display and press
[Enter] to confirm.
Test Mode with Custom Static Colour
The test mode allows you to use the device in a fixed mode with a custom colour. You can define the colour,
pan and tilt positions, and zoom. You can also dim the colour using DMX channel 6.
To set up the test mode:
1. Press [Test Mode] and set the following options:
[PAN]: set the pan position (0-255).
o
[TILT]: set the tilt position (0-255).
o
[FOCUS]: set the zoom factor (0-255) for a broad (0) or narrow (255) beam of light.
o
[RED]: set the brightness of the red LEDs (0-255).
o
[GREEN]: set the brightness of the green LEDs (0-255).
o
[BLUE]: set the brightness of the blue LEDs (0-255).
o
[WHITE]: set the brightness of the white LEDs (0-255).
o
2. To dim this colour using DMX control, set channel 1 to 255; channels 2-5 to 0; and then use channel 6 to
set the dimmer.
Note: If you want to define the static colour using DMX channels 2-5, make sure to set channel 6 back to 0.

Viewing System Information

To view system information, press [Sys Info] in the main menu. The display shows the following information:
[On Time]: the time the device has been operational since the last power-on, in hours/minutes/seconds.
[Run Time]: the total time the device has been operational, in hours/minutes.
[Soft Ver]: the software version.
[Running Mode]: the current running mode, for example [DMX Mode], [Auto Mode], [Sound Mode].
[DMX Address]: the current DMX start address (001-512).
7.3

Stand-Alone Mode

Automatic Mode
In automatic mode, the device runs one of the built-in programs.
To set the device to automatic mode:
1. Connect nothing to the DMX input [2] of the device.
2. In the main menu, press [Run Mode] and select [Auto].
3. Press [Enter] and select a built-in program (AUTO1-AUTO8). A check mark (√) appears next to the option.
Sound-Activated Mode
In sound-activated mode, the device reacts to sound, running through the built-in programs.
To set the device to sound-activated mode:
1. Connect nothing to the DMX input [2] of the device.
2. In the main menu, press [Run Mode].
3. Select [Sound] and press [Enter] to confirm. A check mark (√) appears next to the option.
V. 01 – 07/06/2013
VDPL3610MHZ
6 ©Velleman nv