Esmach NSE 30 Notice D'utilisation Et De Maintenance page 45

THE GRID DOES NOT REST CORRECTLY ON THE SUPPORT PINS
(ON MODELS: NSE 60-NSE 80-NSE 100-NSE 130-NSE 160-NSE 200 –SPIRAL
80-SPIRAL 110-SPIRAL 150-SPIRAL 200-SPIRAL 300)
If the grid does not rest correctly on the stroke end pins, they can be adjusted.
Follow the sequence below:
-open the head cover via the respective screws (figure n° 64)
Figure n° 65
-as the pin is eccentric, simply hold it with a pair of pliers,
loosen the internal screw and adjust the pin by rotating it to
the correct position (figure n° 66)
-re-insert the cable and re-fit the cover.
-slide the cable connecting the con-
trol panel to the power panel out of
the brackets located inside the head cover (figure n° 65)
-rest the cover on the ground
Figure n° 64
Figure n° 66
49