Esmach NSE 30 Notice D'utilisation Et De Maintenance page 39

- Slide the cable connecting the control panel to the
power panel out of the brackets inside the head cover
(figure no. 34).
- Rest the cover on the ground.
Figure n° 35
- Unscrew the four screws securing the motor plate (figure no.
37) and adjust the screw holding the plate (figure no. 38).
- Retighten the motor plate screws and refit the cable connecting the control panel to the
power panel in the brackets.
- Refit the cover.
Figure n° 37
- Loosen the top and bottom handwheels at the rear of the ma-
chine (figures no. 35 and 36)
Figure n° 34
Figure n° 36
Figure n° 38
43