Domo DO158A Mode D'emploi page 36

STORAGE
· Empty and dry the water reservoir.
· Make sure the honeycomb filter is dry before storing it. See drier function below.
· Wrap the device so that dust cannot get inside.
· You can use the water reservoir fastener clips to hold the cord.
Drier function
The cooler/humidifier function pumps water to the honeycomb filter. We recommend that you allow the
filter to dry after use for reasons of hygiene and to extend its service life. To turn on the drier function, do
the following:
· Press the speed button for 3 seconds.
· The speed will flash on the display.
· The drier function lasts 20 minutes and then automatically turns off. The other buttons do not work
while this function is activated.
· If you want to turn the drier function off earlier, press the on-off button. You cannot then restart the
drier function. If you want to use the drier function again, you must start from the beginning.
SPECIFICATIONS
Model identifier(s): DO158A
Item
Heat output
Nominal heat output
Minimum heat output
(indicative)
Maximum continuous
heat output
Auxiliary electricity
consumption
At nominal heat
output
At minimum heat
output
In standby mode
36
DO158A
Symbol Value Unit
Pnom 2.000 kW
Pmin 1.181 kW
Pmax 1.929 kW
--- --- ---
elmax N/A kW
elmin N/A kW
elSB 0.00026 KW
Item
Type of heat input, for electric storage
local space heaters only
manual heat charge control,
with integrated thermostat
manual heat charge control
with room and/or outdoor
temperature feedback
electronic heat charge control
with room and/or outdoor
temperature feedback
fan assisted heat output
Type of heat output/room temperature
control
single stage heat output and
no room temperature control
Two or more manual stages,
no room temperature control
with mechanic thermostat
room temperature control
with electronic room
temperature control
Unit
N/A
N/A
N/A
N/A
No
No
No
Yes