Control Panel; Before The First Use; Remote Control - Domo DO158A Mode D'emploi

PARTS
1.

Control panel

2. Display
3. Horizontal slats
4. Water level indication
5. Wheels
6. On-off switch
7. Handle / remote control holder
8. Honeycomb water filter
9. Dust filter
10. Water reservoir fastener clips / Cord storage
11. Water tank
12. Refrigerating elements
13.

Remote control

CONTROL PANEL
14. MODE: mode button
15. TIMER: timer button
16. HEATER: heater button
17. COOLER/HUMIDIFIER: cooler/humidifier
button
18. SPEED: speed button
19. SWING: oscillation button
20. ON/OFF: on/off button

BEFORE THE FIRST USE

· Carefully remove the device from the packaging. Remove any promotional stickers.
· Clean the outside of the device with a soft damp cloth.
· Secure the wheels at the bottom of the device. Push the wheels into the provided openings.
REMOTE CONTROL
You can also operate the device with the included remote control. Insert a
CR2032 button battery in the battery compartment on the back of the remote
control.
USE
Plug the power cord into a socket. Use the power switch on the back side of the device to turn it on. A
beep indicates that the device is in standby mode. You can control the fan from the control panel or with
the remote control.
The appliance emits an acoustic signal each time a button is pressed. You can turn this signal on or off by
pressing both the cooler/humidifier and heater buttons at the same time for 3 seconds.
The display shows the selected settings. The temperature shown on the display is the ambient
temperature.
32
DO158A
1
2
3
4
5
12
14 15 16
6
7
8
10
11
13
17 18 19 20
9