Mode Button; Cleaning And Maintenance - Domo DO158A Mode D'emploi

MODE BUTTON

You use the heater function button to select the temperature. With the cooler function, you can use this
button to set four wind modes: intelligent, natural, sleep, and normal.
Intelligent
A symbol appears on the display to indicate that this mode is activated. You cannot select the speed.
The device selects the most suitable speed based on the ambient temperature.
· Temperature lower than 25 °C: low speed
· Temperature between than 25 °C and 29 °C: medium speed
· Temperature above 29 °C: high speed
Note: the speed is not adjusted on the display.
Natural
A symbol appears on the display to indicate that this mode is activated. The ventilator will
automatically and randomly change the speed to emulate a natural airflow. The ventilator will alternate
between different speeds to imitate a natural and comfortable sea breeze. In the natural mode, you can
also select a high, medium, or low speed cycle. In other words, a strong, moderate, or weak sea breeze.
Sleep mode
A symbol appears on the display to indicate that this mode is activated. The ventilator distributes a
natural breeze that decreases in strength every half hour. This mode offers 3 speeds:
· High: 30 minutes of high speed, then 30 minutes of medium speed, then continues working at
low speed
· Medium: 30 minutes of medium speed, then continues working at low speed
· Low: natural breeze at low speed
Normal
No symbol is visible on the display. In this setting, you can select 4 speeds using the speed button. The fan
will maintain a constant speed in accordance with the speed configuration.

CLEANING AND MAINTENANCE

· Turn off the device using the power switch. Remove the plug from the socket before cleaning the
appliance.
· The dust filter can be cleaned with water and a soft brush. Dry thoroughly before placing it back. The
filter can be removed by pulling this strongly towards you.
· Replace the honeycomb filter every 1 to 2 months for optimal operation. You can also wash it with
water and a mild detergent. Rinse thoroughly and allow to dry.
· Clean the water reservoir once a month for optimal and hygienic operation. Remove the water
reservoir from the device and clean with some mild detergent and water. Empty the water reservoir,
dry it off and return it to the device.
· Regularly vacuum the air vent at the front to remove dust. Or wipe clean with a damp cloth.
! Never immerse the device, power cord, or plug in water or any other liquid.
Do not use chemicals or abrasive products to clean the device.
www.domo-elektro.be
35
DO158A