Electrical Connection - Pentair STA-RITE AT Série Instructions De Service

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
CHAPTER 3
INSTALLATION
Install the control box on the wall in a room without risk of water overflow. Mount the control box in such a way to maintain the IP
protection grade, fixing holes must be occupied with theirs screws and cable entries with their cables.
DANGER
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the
appliance.
CHAPTER 4

ELECTRICAL CONNECTION

NOTE
The cover of the control box can be opened only with the switch in OFF position.
The connections to the electrical mains and to the pump must be executed by qualified personnel following wiring diagrams.
DANGER
Ensure power is cut to all the connections.
Perform the electrical connections in compliance with local standards in force.
Connect the power by means of a cord
with suitable section in accordance
with applicable standards
CHAPTER 5
MAINTENANCE
Do not open the control box before having disconnected it from the power mains. In case of damage, the replacement must be done by
qualified personnel only.
NOTE
The switch can be opened also in case of thermal protection running (AT series).
4
The power of the control box must
foresee a short circuit protection
device and a differential device with
working current 30 mA
The control box must foresee a
disconnection device from mains with
opening contact of least 3mm

Publicité

Table des Matières
loading

Table des Matières